Boat antifouling is surely the best method to maintain the performance of the boat. Apart from cleaning, applying antifouling to the boat from time to time also helps to keep the boat in the best condition. Thus, thanks to its various biocides and binders, this boat paint can limit the proliferation of parasitic marine organisms on the boat’s hull.
When to apply antifouling?
Indeed, the application of antifouling is not the same as careening. Careening is just cleaning the hull. With regard to this equipment, it must be done regularly to prevent marine organisms from becoming embedded in the boat’s hull. The application of this material is required when the hulls start to deteriorate.
How to prepare for antifouling?
However, before applyingboat antifouling, there are certain conditions to review. Once the boat is out of the water and in dry dock, the application of this product to the boat can be started. Regular use of antifouling on the hull of the boat can be a way to keep the boat performing well.
However, the application of a boat antifouling requires some preparation. Both for the boat and for the person doing it.
-for the boat: Before starting the antifouling, the boat must be out of the water. Furthermore, the boat should be as dry as possible. Therefore, the boat should be raised to make the task easier.
-for the person: the person carrying out the task should still protect him/herself by wearing a suit, mask and goggles.
When to apply the antifouling?
It is best to wait until morning or early afternoon to applyantifouling. If you linger during the day, the paint may deteriorate due to the cold, or even peel off. It will be better if you do the antifouling in a well ventilated environment.
Steps to follow when antifouling a boat
If you have neglected to maintain your boat before, the old boat paint may still be on the boat. Once the boat is completely dry, remove the old paint with an abrasive pad. Then rinse with clean water and allow to dry. Then apply a suitable primer for the boat. Incidentally, these steps can be done a few hours before antifouling. Before proceeding with the antifouling, put tape to mark the parts of the hull.
Finally, to prepare theboat antifouling, you will need a jumping jack and a roller. Mix the antifouling well before applying it to the boat’s hull. Once you are sure that the paint has dried well, remove the tape gently and your boat will be ready to enter the water.
Indeed, the application of a boat antifouling is required if you tend to leave your boat in the water for weeks on end. However, if you are unsure about applying antifouling or are afraid to do so, it is best to seek professional advice.
